FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
93HA-Fabric Manager Server Installation Guide
Figure 80: Three-hole bar nut alignment
Note: Figure 80 depicts the right-side rails of the cabinet. This figure does not depict
the square alignment washers required if you are installing the bar nuts in an HP
9000, 10000, or 11000 series cabinet.
b. Attach each bar nut using two screws (first and third holes) per nut.
Note: If you are installing the bar nuts on an HP 9000, 10000, or 11000 series
cabinet, add a square alignment washer to each screw, orienting the protruding
alignment bumps with the rack-mounting standard.
c. Partially tighten each screw, leaving enough space for the front and rear
bracket flanges to insert between the rack-mounting standards and bar
nuts.