FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
98 HA-Fabric Manager Server Installation Guide
Note: If you are installing the server in an HP 9000, 10000, or 11000 series rack you
will also need to install a square alignment washer with each hexagonal-nut standoff.
5. As shown in Figure 85, use the two (2) remaining pan-head Phillips screws
(#10 x 1/2) to secure the server rack- mount ears (factory-installed on the
server) to the hexagonal-nut standoffs. Secure the screws with a #2 Phillips
screwdriver.
Figure 85: Install hexagonal-nut standoffs and securing screws
Note: Figure 85 does not depict the square alignment washers required between the
hexagonal-nut standoff and rack standard in an HP 9000, 10000, or 11000 series
cabinet
6. Proceed to “Connect the HAFM Server” on page 22.