958-000289-003, March 2005)

Installing and configuring the director36

8. Make sure the shelf bracket is level, and align the rear of the shelf bracket with the appropriate

position on the rear rail (Figure 11).

9. Repeat step 4 through step 7 for the rear end of the shelf bracket.

10.Repeat step 1 through step 9 for the second shelf bracket.

11.Completely tighten all screws attaching shelf brackets to the rack’s rails.

12.Using a torque driver, torque the screws to 22 in/lb.

Prepare the switch for installation

The following section describes how to install the mounting hardware that attaches the switch to the

rails. This hardware includes:

• Two front mounting brackets

• Two rear mounting plates

• Ten cage nuts

• Eight screws

Figure 11 Securing shelf brackets

1 Marker hole

2 Square opening in rail

3 Screws with captive lock and flat washers

4 Square alignment washers

SHR-2265B