958-000289-003, March 2005)

Director 2/64 installation guide 39

NOTE: Ensure that the angle bracket is in contact with the outside surface of the mounting plate.

Figure 13 Aligning the switch in the rack

3. Loosely attach the rear angle bracket to the rack rail with the two panhead Phillips screws

provided (Figure 14).

4. Repeat step 2 and step 3 for the corresponding rear angle bracket (Figure 14).

5. The two rear angle brackets now touch the outside surfaces of the rear mounting plates. Slide

the switch all the way into the rack to where the front mounting bracket meets the rack rails.

6. If you are certain that the hardware lines up properly, secure the hardware as follows:

a. Secure each rear mounting plate to the rear angle bracket with the two screws provided.