958-000289-003, March 2005)

Director 2/64 installation guide 53

9. At the back of the rack, tighten the screws that attach the sliding shelf rails to the mounting

brackets (Figure 27 2).

Figure 28 Positioning the sliding shelf bracket at the rack front

Recommended cable management

Perform the following procedure after installing a switch (Figure 29):

1. Install two cable restraints (1) on each side of the rack in positions that will hold the Fibre

Channel cables away from the power supply.

2. Form loose bundles of the installed Fibre Channel cables (2) on each side of the rack.