958-000289-003, March 2005)

Installing and configuring the director58

• Bits per second: 115200

• Data bits: 8

•Parity: None

• Stop bits: 1

• Flow control: Hardware

8. Click OK.

The HyperTerminal window appears.

9. At the > prompt, enter the user-level password (the default is password) and press Enter. The

password is case-sensitive.

The HyperTerminal window appears with a C> prompt at the top of the window (Figure 34).

10.At the C> prompt, enter ipconfig and press Enter.

The HyperTerminal window lists the following:

•MAC Address

• IP Address (default is 10.1.1.10)

• Subnet Mask (default is 255.0.0.0)

• Gateway Address (default is 0.0.0.0)

•Auto Negotiate

•Speed

•Duplex

Only the IP Address, Subnet Mask, and Gateway Address fields are configurable.

Figure 34 HyperTerminal window

11.To change director network addresses, enter the following at the C> prompt:

ipconfig xxx.xxx.xxx.xxx.yyy.yyy.yyy.yyy.zzz.zzz.zzz.zzz

The IP address format is xxx.xxx.xxx.xxx. The subnet mask format is yyy.yyy.yyy.yyy.

The gateway address format is zzz.zzz.zzz.zzz. The octets xxx, yyy, and zzz are

decimals from 0 through 255. If a network address is to remain unchanged, enter the current

address in the respective box.

12.Press Enter.