958-000289-003, March 2005)

Director 2/64 installation guide 59

When the new network addresses are configured at the director, the message Request

completed OK appears at the bottom of the HyperTerminal window.

13.Select Exit from the File menu.

A HyperTerminal dialog box appears (Figure 35).

Figure 35 HyperTerminal dialog box (1)

14.Click Yes.

A second HyperTerminal dialog box appears (Figure 36).

Figure 36 HyperTerminal dialog box (2)

15.Click No to exit and close the HyperTerminal application.

16.Power off the maintenance terminal:

a. Select Start > Shut Down.

The Shut Down Windows dialog box appears.

b. Select Shut down and then click OK to power off the PC.

17. Disconnect the RS-232 null modem cable from the director and the maintenance terminal.

Replace the protective cap over the maintenance port.

LAN-connect the director

Use these steps to connect the rack-mounted director to the Ethernet LAN segment.