958-000289-003, March 2005)

Installing and configuring the director60

1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2 card (Figure 37).

Figure 37 LAN-connect the director

2. Connect the remaining end of each Ethernet cable to the LAN as directed by the customer’s

network administrator.

NOTE: If an HAFM appliance is not available, use the Embedded Web Server (EWS) interface.

Attach the Ethernet LAN segment to an Internet connection.

HAFM appliance

To run HAFM software, you must set up and configure the HAFM appliance. Refer to the HP

StorageWorks HA-Fabric Manager appliance installation guide for instructions on:

• Setting up the HAFM appliance

• Connecting the HAFM appliance to the LAN

• Configuring the network addresses and passwords for the HAFM appliance

• Setting HAFM appliance date and time

• Configuring and enabling event notification features

• Creating HAFM user names and passwords

1 Remote workstation

2 Ethernet hub or switch (customer

supplied)

3 HAFM appliance (laptop or

rack-mount)

4 Director 2/64