958-000289-003, March 2005)

Director 2/64 installation guide 61

Enabling HAFM to manage the director

A new director must be recognized by the HAFM application to be managed. Follow these steps to

enable HAFM to recognize a new director:

1. At the HAFM application, select Discover > Setup.

The Discover Setup dialog box appears (Figure 38).

Figure 38 Discover Setup dialog box

2. Click Add.

The Domain Information dialog box appears with the IP Address page open (Figure 39).

Figure 39 Domain Information dialog box (IP Address page)

3. Enter a director description in the Description box.

4. Enter the IP address you configured earlier. See ”Configure director network information” on

page 54.

5. Enter the director subnet mask (determined by the customer network administrator) in the Subnet

Mask box.

6. If you want to generate a sequence of IP addresses, perform the following:

a. Select the Generate a sequence of IP addresses box.

b. Enter the last IP address in the Last IP box.

NOTE: All IP addresses in a sequence must be on the same subnet and have the same first three

octets.