958-000289-003, March 2005)

Installing and configuring the director64

• Synchronize date and time, page 64

Figure 41 Configure Date and Time dialog box

Set date and time manually

Use these steps to set the director date and time manually:

1. At the Configure Date and Time dialog box, select the Periodic Date/Time Synchronization box

to deselect the option (no check in the box).

The grayed-out Date and Time fields activate.

2. Click the Date boxes that require change, and enter numbers in the following ranges:

Month (MM): 1 through 12

Day (DD): 1 through 31

Year (YYYY): greater than 1980

3. Click the Time boxes that require change, and enter numbers in the following ranges:

Hour (HH): 0 through 23

Minute (MM): 0 through 59

Second (SS): 0 through 59

4. Click Activate to set the director date and time.

Synchronize date and time

Use these steps to set the director to periodically synchronize date and time with HAFM:

1. At the Configure Date and Time dialog box, select the Periodic Date/Time Synchronization box.

The Date and Time boxes are grayed-out and not selectable.

2. Click Activate to enable synchronization.

The director date and time synchronize with the HAFM date and time at the next update period

(at least once daily).

3. Click Sync Now to synchronize the director and HAFM immediately.

The Date and Time Synced dialog box appears.

Figure 42 Date and Time Synced dialog box

4. Click OK.

5. Click Activate to enable synchronization.