958-000289-003, March 2005)

Installing and configuring the director76

If any port speed was changed, an information message box appears stating, “Port

speed changes will temporarily disrupt port data transfers. Would

you like to continue?”

4. Click Yes to complete activation.

Configuring port addresses (FICON)

If the director is set to FICON management style, perform this procedure to access the director

matrix and define Fibre Channel port names, configure ports as blocked or unblocked, and define

the CUP name. For instructions on configuring port addresses, refer to HP StorageWorks Director

Element Manager user guide for details.

Configuring SNMP trap message recipients

Use this procedure to configure community names, write authorizations, network addresses, and

UDP port number for up to 12 SNMP trap message recipients. A trap recipient is a management

workstation that receives notification through SNMP.

1. At the Hardware View page, select Configure > SNMP Agent.

The Configure SNMP dialog box appears (Figure 47).

Figure 47 Configure SNMP dialog box

a. For each trap recipient to be configured, enter a community name of 32 or fewer

alphanumeric characters in the associated Community Name box. The community name is

incorporated in SNMP trap messages to ensure against unauthorized viewing or use.

b. Click the box in the Write Authorization column to enable or disable write authorization for

the trap recipient (default is disabled).

A check in the box indicates write authorization is enabled. When the feature is enabled, a

management workstation user can change the HAFM appliance’s sysContact, sysName, and

sysLocation SNMP variables.

c. Enter the IP address or DNS host name of the trap recipient (SNMP management

workstation) in the associated Trap Recipient box. Use 64 or fewer alphanumeric characters.

HP recommends using the IP address.

d. Enter a decimal user datagram protocol (UDP) port number in the associated UDP Port

Number box. (This number is commonly 162.)