958-000289-003, March 2005)

Director 2/64 installation guide 77

2. To enable transmission of trap messages to configured SNMP management workstations, select

Enable Authorization Traps.

A check appears in the box when transmission is enabled.

3. Click Activate to save the information and close the dialog box.

Configuring and enabling e-mail notification

Use this procedure to configure and enable e-mail addresses and Simple Mail Transfer Protocol

(SMTP) server addresses to receive e-mail notification of director (and other managed product)

events. The addresses must be configured via HAFM, then enabled.

Use these steps to configure and enable e-mail and SMTP server addresses:

1. At the HAFM main page, select Monitor > Event Notification > Email.

The Email Event Notification Setup dialog box appears (Figure 48).

Figure 48 Email Event Notification Setup dialog box

2. To enable e-mail transmission of configured addresses, select Enable Email Event Notification.

A check appears in the box when transmission is enabled.

NOTE: The enable function must be activated for each director or switch through the Element

Manager. E-mail notification can be active for some directors or switches and inactive for others.

3. Enter the IP address or DNS host name of the SMTP server in the E-mail Server box. Use 64 or

fewer alphanumeric characters.

4. Enter the e-mail address to which e-mail replies should be sent in the Reply box.

5. At the Summary Interval box, enter the length of time the application should wait between

notifications. Select seconds, minutes, or hours from the associated list.

6. To specify users that are to receive e-mail notification, select User List.