958-000289-003, March 2005)

Installing and configuring the director84

Figure 56 New Threshold Alerts dialog box—summary screen

12.Click Finish.

The Configure Threshold Alerts dialog box appears (Figure 57).

Figure 57 Configure Threshold Alerts dialog box

13.At this point, the alert is not active. To activate the alert, select the alert information that appears

in the Configure Threshold Alerts list and then click Activate.

The alert is activated.

Modifying alerts

Use the following steps to modify an existing threshold alert configuration.

1. At the Hardware View page, select Configure > Threshold Alerts.

The Configure Threshold Alerts dialog box appears.

2. Select the alert that you want to modify from the list. If the alert is active, an error message

appears prompting you to deactivate the alert.

3. Click Deactivate if necessary, and then select the alert information in the table again.

4. Click Modify.

An initial Modify Threshold dialog box appears.

5. Make the appropriate changes to the threshold type.

6. Click Next.

A Modify Threshold dialog box appears, where you can change the % utilization, cumulative

minutes for the threshold to occur before notification, and the time interval for measuring

throughput and for alert notification.

7. Make the appropriate changes, and then continue through the Modify Threshold dialog boxes.

Make changes as necessary, until the summary screen displays the alert configuration.

NOTE: At any time you can click Previous or Next to display the desired Modify Threshold dialog

box and change parameters.