958-000289-003, March 2005)

Director 2/64 installation guide 87

Enabling Embedded Web Server

Use the following steps to enable EWS:

1. At the Hardware View page, select Configure > Enable Web Server.

Selecting Enable Web Server automatically places a check in the box.

2. Select Enable Web Server again to remove the check and disable the EWS interface.

When disabled, remote users cannot access the interface.

For complete procedures on using EWS, refer to the HP StorageWorks Embedded Web Server user

guide.

Enabling Telnet

Use the following steps to enable Telnet:

1. At the Hardware View, select Configure > Enable Telnet.

Selecting Enable Telnet automatically places a check in the box.

2. Select Enable Telnet again to remove the check and disable telnet access.

When disabled, remote users cannot access the director through telnet.

Connecting cables to the Fibre Channel ports

Use these steps to connect Fibre Channel port cables:

1. Route the fiber-optic cables from customer-specified devices to ports at the front of the director

(Figure 59).

Figure 59 Connect the Fibre Channel cables

1 Director 2/64

2 Fibre Channel cables

3 Workstation