958-000289-003, March 2005)

Installing and configuring the director90

• HP PA-RISC processor with a 400 MHz or greater clock speed, using the HP-UX 11 or

higher operating system.

•Sun Microsystems

® UltraPARC-II processor with a 300 MHz or greater clock speed, using the

Solaris Version 7.0 or higher operating system.

•IBM POWER3-II

® microprocessor with a 333 MHz or greater clock speed, using the AIX

Version 4.3.3 or higher operating system.

• At least 150 MB (Windows-based) or 350 MB (UNIX-based) available on the internal hard

drive.

• 512 MB or greater RAM.

• Video card supporting 256 colors at 800 x 600 pixel resolution.

• Ethernet network adapter.

• Java-enabled Internet browser, such as Microsoft Internet Explorer (Version 4.0 or later) or

Netscape Navigator (Version 4.6 or later).

Installing HAFM client on a remote workstation

Use these steps to install HAFM on a remote client:

1. Verify the workstation and the Ethernet LAN segment (with the director attached) are connected

through the Internet.

2. At the workstation, launch the browser application.

3. At the browser, enter the HAFM appliance IP address.

4. The HAFM splash screen appears (Figure 61), with the following options.

a. Install HAFM remote client application—Select this option to install the application for your

workstation platform. Advance to step 5.

b. Download SNMP MIB files—The Management Information Base (MIB) files are provided in

standard ASN.1 syntax and may be installed into the MIB database of any SNMPv2

compliant Network Management Station.

Figure 61 HAFM remote client install