958-000281-003, March 2005)

Installation instructions10

Supported UPM kits

HP sells the StorageWorks Director 2/64 with a base configuration of 32 Fibre Channel ports and

the StorageWorks Director 2/140 with a base configuration of 64 Fibre Channel ports. HP also

sells optional kits to increase the number of ports to a maximum of 64 for the Director 2/64 and a

maximum of 140 for the Director 2/140.

Use the procedures described in this chapter for the following UPM kits for both Director switches:

• 8-Port UPM Kit, 300833-B21 (A6574B), which contains (2) Short-wave, 4-port cards, which

includes (8) short-wave 2 Gbps SFP optical transceivers

• 4-Port UPM Kit, 316094-B21, which contains: (1) Short-wave, 4-port card, which includes (4)

short-wave 2 Gbps small form-factor pluggable (SFP) optical transceivers

Each kit also contains:

• (1) Loop back plug (multi-mode/short wave)

• (1) Port card installation instructions

•(1) Warranty

Installing UPM cards

This section describes procedures to install one UPM card. If you are installing more than one UPM

card, ensure that you perform the procedures for all UPM cards you install.

ESD information

CAUTION: To avoid causing machine errors or damage while working on the director, follow

ESD procedures by connecting a grounding cable to the director chassis and wearing an ESD wrist

strap.

• The ESD grounding point for the front of the Director 2/64 chassis is located at the bottom

center, adjacent to the left power supply, as shown in Figure 1.

• The ESD grounding points for the front of the Director 2/140 chassis are located at the front

and rear sides of the chassis, as shown in Figure 2.

• The ESD grounding point for the rear of the Director 2/64 chassis is located at the bottom

center, directly below the maintenance port, as shown in Figure 3.

Touch the chassis once before performing any maintenance action, and once each minute while

installing UPMs. If the director is not connected to facility power (and therefore is not grounded),

connect the ESD wrist strap to an approved bench grounding point instead of the chassis.

Figure 1 shows a cable management assembly for the Director 2/64 that is used only with the

9000, 10000, and 11000 series cabinets.

For the Director 2/64, rotate the cable management assembly, if used, to reach the grounding

point. The assembly locks into the raised position. Any cables attached to the Director 2/64 are