958-000281-003, March 2005)

Universal port module kit installation instructions 17

Figure 6 Director 2/64 UPM card installation

Figure 7 Director 2/140 UPM card installation

4. Secure the UPM card as follows:

CAUTION: The torque tool supplied with the director is designed to tighten logic cards and is set

to release at a torque value of six inch-pounds. Do not use an Allen wrench or torque tool designed

for use with another HP product. Use of the wrong tool may overtighten and damage logic cards.

a. Insert the torque tool into the cam Allen screw (uncolored). Turn the torque tool clockwise

until you feel it release and hear a clicking sound.

As the screw turns clockwise, the card cams into the backplane connector.

b. Insert the torque tool into the locking Allen screw (yellow). Turn the torque tool clockwise

until you feel it release and hear a clicking sound.

As the screw turns clockwise, the card locks into place.

c. Verify the card stiffener is flush with the front of the card cage and even with other director

logic cards.

1 UPM Filler Blank 2 Torque Tool