958-000281-003, March 2005)

Installation instructions18

5. Perform an external loopback test for all ports on the UPM card. For instructions, refer to

”External loopback test” on page 19 and then return here. If the test fails, see the “Maintenance

Analysis Procedures (MAP)” in the Diagnostics chapter of the HP StorageWorks Director 2/64

service manual or HP StorageWorks Director 2/140 service manual to isolate the problem and

then return here.

6. Disconnect the ESD wrist strap from the director chassis and your wrist.

7. Inspect the UPM card to ensure all amber LEDs are extinguished.

If any amber LEDs are illuminated, go to “MAP 0000: Start MAP” of the HP StorageWorks

Director 2/64 service manual or HP StorageWorks Director 2/140 service manual to isolate

the problem and then return here.

8. In the HA-Fabric Manager server, open HAFM.

The Product View appears.

9. Double-click the icon representing the director for which the loopback test is performed.

The Hardware View for the selected director appears.

10.From the Logs menu. select Event Log.

The Event Log appears.

11.Ensure the following event codes are displayed in the log:

• 500–UPM card hot-insertion initiated

•501–UPM card hot-insertion completed

If an event code 501 is not displayed in the log, go to “MAP 0000: Start MAP” of the

HP StorageWorks Director 2/64 service manual or HP StorageWorks Director 2/140 service

manual to isolate the problem and then return here.

12.In the Hardware View, double-click the graphic representing the replacement card to open the

Port Card View.

13.In the Port Card View:

a. Ensure no alert symbols are displayed that indicate a failure (yellow triangle or red

diamond).

b. Verify UPM card information (FRU name, position, and state) is correct.

If a problem is indicated, go to “MAP 0000: Start MAP” of the HP StorageWorks Director

2/64 service manual or HP StorageWorks Director 2/140 service manual to isolate the

problem and then return here.

14.Close and lock the equipment cabinet door.

15.Initiate communication to the UPM card and set the card online as needed. For instructions,

refer to ”Unblocking a UPM card” on page 22.