FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

2
Task 11: Configure the Director at the SANpilot Interface
2-81
Installation Tasks
• Open the SANpilot interace (Subtask B: Open the SANpilot Interface
on page 2-82
• Configure ports (Subtask C: Configure Director Ports on page 2-84).
• Configure BB Credit (Subtask D: Configure BB Credit on page 2-85).
• Configure director identification (Subtask E: Configure Director
Identification on page 2-86).
• Configure director date and time (Subtask F: Configure Date and
Time on page 2-88).
• Configure operating parameters (Subtask G: Configure Operating
Parameters on page 2-89).
• Configure fabric parameters (Subtask H: Configure Fabric
Parameters on page 2-91).
• Configure network information (Subtask I: Configure Network
Information on page 2-94).
• Configure SNMP trap message recipients (Subtask J: Configure
SNMP on page 2-95).
• Enable command line interface (CLI) (Subtask K: Enable or Disable
the CLI and SSH on page 2-97).
• Enable host control (Subtask L: Enable or Disable OSMS and Host
Control on page 2-98).
• Configure user rights (Subtask M: Change User Password on
page 2-99).
• Configure port binding (Subtask N: Configure Port Binding on
page 2-100).
• Configure switch binding (Subtask O: Configure Switch Binding on
page 2-101).
• Configure fabric binding (Subtask P: Configure Fabric Binding on
page 2-106).
• Enable Enterprise fabric mode (Subtask Q: Enable or Disable
Enterprise Fabric Mode on page 2-107).
• Configure OpenTrunking (Subtask R: Configure OpenTrunking on
page 2-108).
• Install feature keys (Subtask S: Install Feature Keys on page 2-111).