FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

2
Task 11: Configure the Director at the SANpilot Interface
2-89
Installation Tasks
2. Click Activate to save and activate the changes. The message Your
changes to the date/time configuration have been successfully
activated appears.
Subtask G: Configure Operating Parameters
Perform this procedure to configure the director preferred domain
ID, insistent domain ID, rerouting delay, and domain registered state
change notifications (RSCNs).
To configure parameters:
1. Set the director offline.
a. At the Configure panel, select Operations at the left side of the
panel. The Operations panel opens and the Director page
displays with the Beacon tab selected
b. Click the Online State tab, then click Set Offline. The message
Your operations changes have been successfully activated
appears.
2. At the Operations panel, select the Configure option at the left side
of the panel. The Configure panel opens with the Ports page
displayed.
3. At the Configure panel, click the Director tab, then select
Parameters. The Director page displays with Parameters selected
(Figure 2-69).
Figure 2-69 Configure Panel (Director Page with Parameters Tab)