FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

2
2-118
Intrepid® 6064 Director Installation and Service Manual
Installation Tasks
• Enable or disable default zone - To toggle (enable or disable)
the default zone state, click Enable Default Zone or Disable
Default Zone. Depending on the toggle state, the Default Zone
field changes to Enabled or Disabled.
• Disable zone set - To disable the active zone set and place all
attached devices in the default zone, click Disable Zone Set. A
confirmation dialog box displays. Click OK to disable the
active zone set.
• Discard changes - To discard unsaved changes made to a zone
set configuration and revert to a saved zoning configuration,
click Discard Changes. A confirmation dialog box displays.
Click OK to discard the changes.
Task 13: Connect the Director to a Fabric Element
Connect the director to an expansion port (E_Port) of a fabric element
(director or switch) to provide fabric-attached Fibre channel
connectivity.
To connect the director to a fabric element and create an ISL:
1. Ensure the fabric element is defined to the SAN management
application or accessible by the SANpilot interface. If the fabric
element must be defined, refer to the director or switch
installation manual for instructions.
2. Ensure the preferred domain ID for the director is unique and
does not conflict with the ID of another director or switch
participating in the fabric.
— If the domain ID must be changed from the management
server, see Task 8: Configure the Director at the Element Manager
Application on page 2-48.
— If the domain ID must be changed from the SANpilot
interface, see Task 11: Configure the Director at the SANpilot
Interface on page 2-80.
3. Ensure the R_A_TOV and E_D_TOV values for the Intrepid 6064
Director are identical to the values for all directors or switches in
the fabric.
— If the values must be changed from the management server,
see Task 8: Configure the Director at the Element Manager
Application on page 2-48.