FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-2
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
Factory Defaults
Table 3-1 lists factory-set defaults for the Intrepid 6064 Director
passwords (customer and maintenance-level), and the director
Internet Protocol (IP) address, subnet mask, and gateway address.
Quick Start
Table 3-2 lists the MAPs. Fault isolation normally begins at MAP
0000: Start MAP on page 3-9.
However, Table 3-3 lists the event codes and the corresponding
MAPs. It is a quick start, if an event code is readily available.
Table 3-1 Factory-Set Defaults
Item Default
Customer password password
Maintenance password level-2
IP address 10.1.1.10
Subnet mask 255.0.0.0
Gateway address 0.0.0.0
Table 3-2 MAP Summary
MAP Page
MAP 0000: Start MAP 3-9
MAP 0100: Power Distribution Analysis 3-34
MAP 0200: POST Failure Analysis 3-44
MAP 0300: Server Application Problem Determination 3-49
MAP 0400: Loss of Server Communication 3-57
MAP 0500: FRU Failure Analysis 3-75
MAP 0600: Port Card Failure and Link Incident Analysis 3-83
MAP 0700: Fabric, ISL, and Segmented Port Problem Determination 3-105
MAP 0800: Server Hardware Problem Determination 3-121