FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
MAP 0000: Start MAP
3-21
Maintenance Analysis Procedures (MAPS)
Did one of the listed messages appear in the Link Incident Log?
YES NO
↓ The director appears operational. Exit MAP.
A link incident problem is indicated. Go to step 23 to obtain event
codes. If no event codes are found, go to MAP 0600: Port Card
Failure and Link Incident Analysis on page 3-83. Exit MAP.
23
Obtain event codes from the Intrepid 6064 Event Log.
NOTE: If multiple event codes are found, note all codes and associated
severity levels. Record the date, time, and sequence, and determine if the
codes are related to the problem. Begin fault isolation with the most recent
event code with the highest severity level. Other codes may accompany this
event code, or may indicate a normal indication after a problem is recovered.
a. At the Hardware View, click Logs and select Event Log. The
Event Log displays (Figure 3-7).
b. Record the event code, date, time, and severity (Informational,
Minor, Major, or Severe).
c. Record all event codes that may relate to the reported problem.
Figure 3-7 Event Log
Were one or more event codes found?
NO YES
↓ Go to Table 3-3 on page 3-3 to interpret event codes.
Return to the MAP step that sent you here.