FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-22
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
24
Are you at the director reporting the problem?
YES NO
↓ Go to step 36.
25
Is the power LED (green) at the director front bezel illuminated?
NO YES
↓ Go to step 30.
26
Is the director connected to facility AC power and powered on?
NO YES
↓ Go to step 29.
27
Connect the director to facility AC power and set the power switch
(circuit breaker) at the rear of the director to the ON (up) position.
Inspect the director for indications of being powered on:
• At the front bezel, an illuminated power LED (green) or system
error LED (amber).
• An illuminated green LED on the active CTP2 card, and
illuminated green PWR OK LEDs on both power supplies.
• Audio emanations and airflow from cooling fans.
Does the director appear powered on?
YES NO
↓ A power distribution problem is indicated. Go to step 23 to
obtain event codes. If no event codes are found, go to MAP
0100: Power Distribution Analysis on page 3-34. Exit MAP.
28
Is the power LED (green) at the director front bezel illuminated?
NO YES
↓ Go to step 30.
A faulty power LED is indicated, but director and Fibre Channel port
operation is not disrupted. The LED is connected to the circuitry in a