FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-46
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
5
The backplane failed POSTs (indicated by a FRU code 01) and must
be removed and replaced (RRP: Backplane on page 5-36).
• This procedure is nonconcurrent and must be performed while
director power is off.
• Perform the data collection procedure as part of FRU removal
and replacement.
Did backplane replacement solve the problem?
NO YES
↓ The director appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
6
A CTP2 card failed POSTs (indicated by a FRU code 02) and must be
removed and replaced (RRP: CTP2 Card on page 5-7).
• This procedure is concurrent and can be performed while
director power is on.
• Perform the data collection procedure as part of FRU removal
and replacement.
ATTENTION! Do not remove and replace a redundant CTP2 card if the
backup CTP2 card is not fully operational and director power is on. The
director IP address, configuration data, and other operating parameters will
be lost.
Did CTP2 card replacement solve the problem?
NO YES
↓ The director appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
7
An SBAR assembly failed POSTs (indicated by a FRU code 03) and
must be removed and replaced (RRP: SBAR Assembly on
page 5-26).
• This procedure is concurrent and can be performed while
director power is on.