FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-98
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
Figure 3-37 Switch Binding - Membership List Dialog Box
b. At the Switch Binding - Membership List dialog box ensure the
Switch Membership List is updated and correct for each director
or switch, then click Activate for each director or switch. The
switch binding feature is consistently enabled for both directors
or switches.
Did updating the switch membership lists solve the problem?
NO YES
↓ The director appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
31
A port connection is not allowed because of a Computer Network
Technologies (CNT) wide area network (WAN) extension mode
mismatch. Based on switch-to-switch differences between the ELP
maximum frame sizes allowed, a connection was not allowed to a
director set to CNT WAN extension mode.
Contact McDATA support personnel to obtain software maintenance
release 4.02.00. This release is required to correct the problem and
allow McDATA directors or switches to communicate with CNT
UltraEdge WAN Gateways. Exit MAP.