FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
MAP 0600: Port Card Failure and Link Incident Analysis
3-99
Maintenance Analysis Procedures (MAPS)
32
The director and attached device are performing a Fibre Channel link
reset. This is a transient state. Wait approximately 30 seconds and
inspect port state and LED behavior.
Did the link recover and resume operation?
NO YES
↓ The Fibre Channel link and director appear operational. Exit
MAP.
Go to step 1.
33
A link incident message appeared in the Link Incident Log or in the
Link Incident field of the Port Properties dialog box; or an event code
581, 582, 583, 584, 585, or 586 was observed at the console of an
OSI or FICON server attached to the director reporting the problem.
Clear the link incident for the port.
a. At the Hardware View, right-click the port. A pop-up menu
appears.
b. Select Clear Link Incident Alert(s). The Clear Link Incident
Alert(s) dialog box displays (Figure 3-38).
Figure 3-38 Clear Link Incident Alert(s)
c. Select the This port (n) only radio button (where n is the port
number) and click OK. The link incident clears.
d. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓ The problem is transient and the Fibre Channel link and
director appear operational. Exit MAP.