FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-100
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
34
Inspect the fiber-optic jumper cable attached to the port and ensure
the cable is not bent and connectors are not damaged. If the cable is
bent or connectors are damaged:
a. Notify the customer the port will be blocked. Ensure the
customer system administrator quiesces Fibre Channel frame
traffic through the port and sets the attached device offline.
b. Block the port (Blocking and Unblocking Ports on page 4-46).
c. Remove and replace the fiber-optic jumper cable.
d. Unblock the port (Blocking and Unblocking Ports on page 4-46).
Was a corrective action performed?
YES NO
↓ Go to step 36.
35
Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO
↓ The Fibre Channel link and director appear operational.
Exit MAP.
36
Clean fiber-optic connectors on the jumper cable.
a. Notify the customer the port will be blocked. Ensure the
customer system administrator quiesces Fibre Channel frame
traffic through the port and sets the attached device offline.
b. Block the port (Blocking and Unblocking Ports on page 4-46).
c. Disconnect both ends of the fiber-optic jumper cable.
d. Clean the fiber-optic connectors (Cleaning Fiber-Optic
Components on page 4-51).
e. Reconnect the fiber-optic jumper cable.
f. Unblock the port (Blocking and Unblocking Ports on page 4-46).
g. Monitor port operation for approximately five minutes.