FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3
3-116
Intrepid® 6064 Director Installation and Service Manual
Maintenance Analysis Procedures (MAPS)
17
A director E_Port segmented because a build fabric protocol error
was detected.
a. Disconnect the fiber-optic jumper cable from the segmented
E_Port.
b. Reconnect the cable to the same port.
Did disconnecting and reconnecting the cable solve the problem and
did both directors join through the ISL to form a fabric?
NO YES
↓ The directors, associated ISL, and multiswitch fabric appear
operational. Exit MAP.
18
Initial program load (IPL) the director (IML, IPL, or Reset the Director
on page 4-53).
Did the IPL solve the problem and did both directors join through the
ISL to form a fabric?
NO YES
↓ The director, associated ISL, and multiswitch fabric appear
operational. Exit MAP.
Perform the data collection procedure and contact the next level of
support. Exit MAP.
19
A director E_Port segmented because no director or switch in the
fabric is capable of becoming the principal switch.
a. Notify the customer the director will set offline. Ensure the
system administrator quiesces Fibre Channel frame traffic
through the director and sets attached devices offline.
b. Set the director offline (Set the Director Online or Offline on
page 4-43).
c. At the Hardware View for the director, click Configure and select
Operating Parameters and Fabric Parameters. The Configure
Fabric Parameters dialog box displays (Figure 3-34).
d. At the Switch Priority field, select Principal, Never Principal, or
Default (the default setting is Default. The switch priority value
designates the fabric principal switch. The principal switch is