FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

3-120

Intrepid® 6064 Director Installation and Service Manual

Maintenance Analysis Procedures (MAPS)

• Failure reason F1 - An invalid response length condition caused

an error in a zone merge frame.

• Failure reason F2 - An invalid response code caused an error in

a zone merge frame.

Disconnect the fiber-optic jumper cable from the E_Port reporting the

problem, then reconnect the cable to the same port.

Did disconnecting and reconnecting the cable solve the problem and

was the resulting zone merge successful?

NO YES

↓ The merged zone appears operational. Exit MAP.

Perform the data collection procedure and return the CD to McDATA

for analysis. Contact the next level of support. Exit MAP.

A zone merge failed during ISL initialization. The following list

explains the reason:

• Failure reason 09 - Invalid data caused a zone merge failure.

• Failure reason 0A - A Cannot Merge condition caused a zone

merge failure.

Obtain supplementary error code data for the 150 event code.

a. At the Hardware View, click Logs and select Event Log. The

Event Log displays.

b. Examine bytes 12 through 15 of event data that specify the error

code. Record the error code.

Perform the data collection procedure and return the CD to McDATA

for analysis. Contact the next level of support, and report the 150

event code, the associated failure reason, and the associated error

code. Exit MAP.

Does the SANpilot interface appear operational?

YES NO

↓ Analysis for an Ethernet link, AC power distribution, or CTP2

card failure is not described in this MAP. Go to MAP 0000:

Start MAP on page 3-9. If this is the second time at this step,

contact the next level of support. Exit MAP.