FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

4
Managing Configuration Data
4-81
Repair Information
3. When the SANpilot interface opens, the View panel and Switch
page appear as the default. At the View panel, select the Operations
option at the left side of the panel. The Operations panel opens
with the Switch page displayed.
4. Click the Reset Config tab. The Switch page displays with the Reset
Config tab selected (Figure 4-70).
Figure 4-70 Operations Panel (Switch Page with Reset Config Tab)
5. Click Reset Configuration. A browser-specific message box
displays (Figure 4-71).
Figure 4-71 Browser-Specific Message Box
6. Click OK to reset the configuration. The message Your changes
have been successfully activated appears.
7. The director IP address resets to the default address of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default address, the browser-to-director Internet
connection is not affected and the procedure is complete.