FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

5-2

Intrepid® 6064 Director Installation and Service Manual

Removal and Replacement Procedures (RRPs)

Procedural Notes

NOTE: The screens in this manual may not match the screens on your server

and workstation. The title bars have been removed and the fields may

contain data that does not match the data seen on your system.

The following procedural notes are referenced as applicable. The

notes do not necessarily apply to all procedures in the chapter.

1. Before performing a FRU repair, read the removal and

replacement procedures for that FRU carefully and thoroughly to

familiarize yourself with the procedures and reduce the

possibility of problems or customer down time.

2. Follow all electrostatic discharge (ESD) procedures, DANGER

and CAUTION statements, and statements listed in the preface of

this manual.

3. After completing the steps of a detailed procedure that is

referenced from another procedure, return to the initial

(referencing) procedure and continue to the next step of that

procedure.

4. After completing a replacement procedure, clear the event code

reporting the failure and the event code reporting the recovery

from the Event Log (at the management server or SANpilot

interface), and extinguish the amber system error light- emitting

diode (LED) at the director front bezel.

Removing and Replacing FRUs

This section describes procedures to remove and replace director

FRUs, along with a list of tools required to perform each procedure.

In addition, the section provides:

• ESD information

• A list of concurrent FRUs. Concurrent FRUs can be removed and

replaced while the director is powered on and operational.

• A list of nonconcurrent FRUs. Nonconcurrent FRUs can only be

removed and replaced after the director is powered off.

See Chapter 6, Illustrated Parts Breakdown for FRU locations and part

numbers.