FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

5
5-24
Intrepid® 6064 Director Installation and Service Manual
Removal and Replacement Procedures (RRPs)
b. Push the cam lever in and to the left to cam the power supply
into the director chassis. Ensure the locking pin is engaged in
the cam lever.
4. Disconnect the ESD wrist strap from the director chassis and your
wrist.
5. Inspect the power supply to ensure the green PWR OK LED is
illuminated and all amber LEDs are extinguished. If a problem is
indicated, go to MAP 0000: Start MAP on page 3-9 to isolate the
problem.
6. Disengage the right-side captive pin of the cable management
assembly, then rotate the assembly 90
0
downward.
7. At the management server or at a web browser connected to the
SANpilot interface, inspect the Event Log. Ensure an event code
207 (power supply installed) appears in the log.
If an event code 207 does not appear in the log, go to MAP 0000:
Start MAP on page 3-9 to isolate the problem.
8. Perform one of the following to verify power supply operation:
— If at the management server, open the Hardware View and
observe the power supply graphic to ensure no alert symbols
appear that indicate a failure (yellow triangle or red diamond).
If a problem is indicated, go to MAP 0000: Start MAP on
page 3-9 to isolate the problem.
— If at a web browser connected to the SANpilot interface, open
the Switch tab at the View panel and ensure no amber LEDs
illuminate that indicate a power supply failure. If a problem is
indicated, go to MAP 0000: Start MAP on page 3-9 to isolate
the problem.
9. Perform the data collection procedure (Collecting Maintenance
Data on page 4-39).
10. Perform one of the following to clear the system error (ERR) LED:
— If at the management server, open the Hardware View and:
a. Right-click the front panel bezel graphic (away from a
FRU) to open a menu.
b. Click the Clear System Error Light menu selection.
— If at a web browser connected to the SANpilot interface: