FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

A
A-4
Intrepid® 6064 Director Installation and Service Manual
Messages
Action Disable FMS before moving slots into a partition
Message Cannot disable switch binding while Enterprise Fabric Mode is
active and the switch is online.
Description The user attempted to disable switch binding through the Switch
Binding Change State dialog box, but Enterprise Fabric Mode is enabled.
Action Either disable Enterprise Fabric Mode using the Enterprise Fabric Mode
dialog box at the SAN management application, or set the director or
switch offline to disable switch binding.
Message Cannot disable Insistent Domain ID while fabric binding is active.
Description The user attempted to disable the Insistent Domain ID parameter
through the Configure Switch Parameters dialog box, but fabric binding
is enabled.
Action Disable fabric binding through the Fabric Binding dialog box before
disabling the parameter.
Message Cannot enable beaconing on a failed FRU.
Description Occurs when selecting Enable Beaconing option for a failed FRU.
Action Replace FRU and enable beaconing or enable beaconing on operating
FRU.
Message Cannot enable beaconing while the system error light is on.
Description Beaconing cannot be enabled while the system error LED is on.
Action Select Clear System Error Light from the Products menu to clear the
error light, then enable beaconing.
Message Cannot enable OpenTrunking while Enterprise Fabric Mode is
active and the switch is offline.