FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

A
Intrepid 6064 Element Manager Messages
A-5
Messages
Description Enterprise Fabric Mode is active, the director or switch is offline, and a
user is attempting to enable OpenTrunking feature. This message
displays only if the feature is installed.
Action Perform one of the following:
•Disable Enterprise Fabric Mode by selecting the appropriate fabric
at the fabric tree portion of the Fabrics view. Open the Enterprise
Fabric Mode dialog box, click Start, and follow the prompts to
disable the feature.
• Set the director or switch online through the Set Online State
dialog box.
Message Cannot have spaces in field.
Description Spaces are not allowed in this field.
Action Remove the spaces or retype the field without spaces.
Message Cannot install firmware to a director with a failed CTP card.
Description Firmware cannot be installed on a director with a failed CTP card.
Action Replace the failed CTP card and retry the firmware install to the
director.
Message Cannot modify director/switch speed. Port speeds cannot be
configured at a higher data rate than the director/switch speed.
Description Port speeds cannot be configured at a higher data rate than the
director speed. This displays when you set the director speed to 1
Gb/sec through the Configure Operating Parameters dialog box and at
least one of the ports is running at 2 Gb/sec.
Action Either return the director speed to 2 Gb/sec or configure all port data
speeds to 1 Gb/sec through the Configure Ports dialog box.
Message Cannot perform this operation while the switch is offline.