FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

A
Intrepid 6064 Element Manager Messages
A-27
Messages
Message: Port diagnostics cannot be performed on an inactive port.
Description: Displays when port diagnostics is run on a port that in an inactive
state.
Action: Perform diagnostics on an active port.
Message: Port speeds cannot be configured at a higher rate than the switch
speed.
Description: An attempt was made to configure a port to 2.125 Gbps or 10.625
Gbps with the director or switch speed set to 1.0625 Gbps.
Action: Set the director speed to 2 Gb/sec or 10 Gb/sec in the Configure
Operating Parameter dialog box.
R
Message R_A_TOV must be greater than E_D_TOV.
Description R_A_TOV value must be greater than E_D_TOV value.
Action Change a value so R_A_TOV exceeds E_D_TOV.
Message Resource is unavailable.
Description The specified operation cannot be performed because the product is
unavailable.
Action Verify the director (or switch)-to-management server link is
operational. If the link is up, the management server may be busy. Try
the operation later.
S
Message Send firmware failed.
Description Send firmware operation failed.
Action Retry the operation. If the condition persists, contact support
personnel and report the problem.