FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

A
A-28
Intrepid® 6064 Director Installation and Service Manual
Messages
Message SNMP trap address not defined.
Description An SNMP trap address must be defined if a community name is
defined.
Action Define an SNMP address.
Message Stop diagnostics failed. The test is already running.
Description Diagnostics for the port were not running and Stop was selected at
the Port Diagnostics dialog box. Diagnostics aborted for some reason,
but the Stop button remains enabled.
Action Verify port operation. Retry diagnostics for the port and select Stop
from the dialog box. If the condition persists, contact support
personnel and report the problem.
Message Stop diagnostics failed. The test was not running.
Description The action to stop diagnostics failed because the test was not running.
Action Information message - no action required.
Message Switch binding was removed from attached devices that are also
participating in port binding. Please review the port binding
configuration.
Description Device WWNs were removed from the switch membership list
(SANtegrity binding feature), but one or more of the devices still has
security controlled by port binding.
Action Verify the security level for each device is specified as required by
reviewing the Bound WWN list at the Configure Ports dialog box.
Message System diagnostics cannot run. The operational status is invalid.
Description System diagnostics cannot run on a director or switch with failed
ports.
Action Replace failed ports.