FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

Event Code Tables
B-1
B
Event Code Tables
An event is an occurrence (state change, problem detection, or
problem correction) that requires user attention or that should be
reported to a system administrator or service representative. An
event usually indicates a director operational state transition, but may
also indicate an impending state change (threshold violation). An
event may also provide information only, and not indicate an
operational state change. Events are reported as event codes.
This appendix lists the three-digit event codes and provides detailed
information about each code. Event codes are listed in numerical
order and in tabular format, and are grouped as follows:
• 000 through 199 - System events.
• 200 through 299 - Power supply events.
• 300 through 399 - Fan module events.
• 400 through 499 - Control processor (CTP/CTP2) card events.
• 500 through 599 - Port card (UPM and XPM) events.
• 600 through 699 - Serial crossbar (SBAR) events.
• 800 through 899 - Thermal events.
Events are recorded in the Intrepid 6064 Event Log, in the event log of
the Web server, at a remote workstation if E-mail and call-home
features are enabled, or at a simple network management protocol
(SNMP) workstation. An event may also illuminate the system error
light-emitting diode (LED) on the director front bezel.
In addition to numerical event codes, the tables in this appendix also
provide a: