FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

B
B-22
Intrepid® 6064 Director Installation and Service Manual
Event Code Tables
Event Code: 150
Message: Zone merge failure.
Severity: Informational.
Explanation: During ISL initialization, the zone merge process failed. Either an incompatible zone set was detected or a
problem occurred during delivery of a zone merge frame. This event code always precedes a 070 ISL
segmentation event code, and represents the reply of an adjacent fabric element in response to a zone merge
frame. Refer to the event data for the failure reason.
Action: Action depends on the failure reason specified in the event data.
Event Data: Bytes 0 - 3 of the event data specify affected E_Port number(s).
Bytes 4 - 7 specify the request SW_ILS command code.
Bytes 8 - 31 specify the request response payload.
Distribution: Director Management Server Host
Nonvolatile
System
Event Log
System
Error LED
Event Log E-Mail Call-Home Sense Info Link Incident
✔✔✔
Event Code: 151
Message: Fabric configuration failure.
Severity: Informational.
Explanation: A fabric-wide configuration activation failed. For example, a zone set activation.
An event 151 is only logged by the managing switch. It is intended to detect and log errors that occur on the
managing switch in the fabric when fabric configuration failures are detected. It is intended to help engineering
personnel determine the cause of fabric-configuration failures.
The event 151 is only possible in EOS versions 5.1 and above. All data values of the event are in big-endian
notation, regardless of the embedded processor. All data values are hexadecimal and range from 0x00000000
and 0x000000FF.
Action: Depends on the failure reason. In most cases, perform the data collection procedure on the managing switch and
the managed switch, and return the CD to McDATA support personnel.