FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

2
Summary of Installation Tasks
2-7
Installation Tasks
Subtask L: Enable or Disable OSMS and Host Control Required if the director is managed through the
SANpilot interface.
2-98
Subtask M: Change User Password Required if the director is managed through the
SANpilot interface.
2-99
Subtask N: Configure Port Binding Required if the director is managed through the
SANpilot interface.
2-100
Subtask O: Configure Switch Binding Required if the director is managed through the
SANpilot interface.
2-101
Subtask P: Configure Fabric Binding Required if the director is managed through the
SANpilot interface.
2-106
Subtask Q: Enable or Disable Enterprise Fabric Mode Required if the director is managed through the
SANpilot interface.
2-107
Subtask R: Configure OpenTrunking Required if the director is managed through the
SANpilot interface.
2-108
Subtask S: Install Feature Keys Optional - configure if a feature key is ordered by the
customer.
2-111
Task 11: Cable Fibre Channel Ports. Required. 2-113
Task 12: Configure Zoning. Perform this task to configure zoning. 2-113
Task 13: Connect the Director to a Fabric Element. Perform this task to connect the director to a fabric. 2-118
Task 14: Register with the McDATA File Center. Required. 2-120
Table 2-3 Installation Task Summary (continued)
Task Number and Description Required or Optional Page