FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

vii
Contents
Contents
Subtask J: Configure Threshold Alerts ................................ 2-67
Subtask K: Configure OpenTrunking .................................. 2-71
Subtask L: Enable SANpilot Interface and Telnet Access. 2-73
Subtask M: Configure, Enable, and Test E-mail Notification...
2-73
Subtask N: Configure and Enable Ethernet Events ........... 2-75
Subtask O: Configure, Enable, and Test Call-Home Notifica-
tion ............................................................................................ 2-76
Task 9: Configure SANtegrity Authentication (Optional)........ 2-77
Accessing SANtegrity Authentication................................. 2-77
Task 10: Back Up Configuration Data ......................................... 2-78
Task 11: Configure the Director at the SANpilot Interface....... 2-80
Subtask A: Connect Director to Internet or Ethernet LAN
Segment.................................................................................... 2-82
Subtask B: Open the SANpilot Interface ............................. 2-82
Subtask C: Configure Director Ports.................................... 2-84
Subtask D: Configure BB Credit ........................................... 2-85
Subtask E: Configure Director Identification...................... 2-86
Subtask F: Configure Date and Time................................... 2-88
Subtask G: Configure Operating Parameters ..................... 2-89
Subtask H: Configure Fabric Parameters ............................ 2-91
Subtask I: Configure Network Information........................ 2-94
Subtask J: Configure SNMP................................................... 2-95
Subtask K: Enable or Disable the CLI and SSH.................. 2-97
Subtask L: Enable or Disable OSMS and Host Control..... 2-98
Subtask M: Change User Password ..................................... 2-99
Subtask N: Configure Port Binding.................................... 2-100
Subtask O: Configure Switch Binding ............................... 2-101
Configuring the Switch Binding Membership List.......... 2-104
Subtask P: Configure Fabric Binding................................. 2-106
Subtask Q: Enable or Disable Enterprise Fabric Mode.... 2-107
Subtask R: Configure OpenTrunking ................................ 2-108
Subtask S: Install Feature Keys ........................................... 2-111
Task 11: Cable Fibre Channel Ports............................................ 2-113
Task 12: Configure Zoning.......................................................... 2-113
Configure Zones (SANpilot Interface) .............................. 2-114
Configure Zone Sets (SANpilot Interface) ........................ 2-117
Task 13: Connect the Director to a Fabric Element.................. 2-118
Task 14: Register with the McDATA File Center ..................... 2-120
Chapter 3 Maintenance Analysis Procedures (MAPS)
Maintenance Analysis Procedures................................................. 3-1