FW 07.00.00/HAFM SW 08.06.00 McDATA Intrepid 6064 Director Installation and Service Manual (620-000108-920, April 2005)

2
Task 8: Configure the Director at the Element Manager Application
2-49
Installation Tasks
• Configure director date and time (Subtask A: Set Director Date and
Time on page 2-50).
• Identify the director to the SAN management (SANavigator or
EFCM) application(Subtask B: Configure Director Identification on
page 2-51).
• Configure director management style (open systems or FICON)
(Subtask C: Configure Director Management Style on page 2-52).
• Configure director parameters (Subtask D: Configure Director
Parameters on page 2-53).
• Configure fabric parameters (Subtask E: Configure Fabric
Parameters on page 2-55).
• Configure preferred paths (Subtask F: Configure Preferred Paths on
page 2-57).
• Configure switch binding (Subtask G: Configure Switch Binding on
page 2-59).
• Configure director ports (Subtask H: Configure Director Ports on
page 2-63).
• Configure SNMP trap message recipients (Subtask I: Configure
SNMP Trap Message Recipients on page 2-66).
• Configure threshold alerts (Subtask J: Configure Threshold Alerts on
page 2-67).
• Configure OpenTrunking (Subtask K: Configure OpenTrunking on
page 2-71).
• Enable SANpilot interface and Telnet access (Subtask L: Enable
SANpilot Interface and Telnet Access on page 2-73).
• Configure and enable e-mail notification (Subtask M: Configure,
Enable, and Test E-mail Notification on page 2-73).
• Configure and enable Ethernet events (Subtask N: Configure and
Enable Ethernet Events on page 2-75).
• Configure and enable call-home notification (Subtask O: Configure,
Enable, and Test Call-Home Notification on page 2-76).