FW 08.01.00 McDATA Intrepid® 6064 Director Installation and Service Manual (620-000108-930, November 2005)

RRP: Cable Management Assembly

5-7

Removal and Replacement Procedures (RRPs)

Figure 5-3 Cable Management Assembly Removal and Replacement

Replacement To replace the cable management assembly:

1. Position the cable management assembly at the front of the

director chassis (Figure 5-3).

2. Disengage both captive pins by pulling them inward, then push

the assembly toward the card cage area.

3. Release the captive pins so they engage in the chassis anchor

points.

4. Route fiber-optic and Ethernet cables through the cable

management assembly. Dress the cables evenly through the

assembly cut-out slots.

5. If necessary, close and lock the equipment cabinet door.