FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

config.switch.domainRSCN
103CLI Reference Guide for Directors and Edge Switches
Syntax
domainRSCN domainRSCNState
Purpose
This command sets the domain RSCN state for the switch. The switch can be
either offline or online when this command is executed. When this parameter is
enabled, domain register for state change notifications (domain RSCNs) are sent
between end devices in a fabric to provide additional connection information to
host bus adapters (HBA) and storage devices. As an example, this information
might be that a logical path has been broken because of a physical event, such as a
fiber optic cable being disconnected from a port.
Parameters
This command has one parameter:
Command Example
Root> config switch domainRSCN 1
Note: The Insistent Domain ID must be enabled, if the Enterprise Fabric Mode (an
optional SANtegrity feature) or Preferred Path is enabled.
config.switch.domainRSCN
domainRSCNState Specifies whether the domain RSCN state is
enabled or disabled. Valid values are enable
and disable. Boolean 1 and 0 may be
substituted as values.