FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

config.switch.zoningRSCN
117CLI Reference Guide for Directors and Edge Switches
Syntax
zoningRSCN zoningRSCNState
Purpose
This command sets the zoning RSCN state for the switch. When enabled, this
parameter allows zoning register for state change notifications (RSCNs) to be sent
to registered members of the fabric. Zoning RSCNs are sent to ports on the switch
following any change to the fabric’s active zone set. The switch can be either
offline or online when this command is executed.
Parameters
This command has one parameter:
Command Example
Root> config switch zoningRSCN 1
config.switch.zoningRSCN
zoningRSCNState Specifies whether the zoning RSCN state is
enabled. Valid values are enable and
disable. Boolean 1 and 0 may be
substituted as values.