FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)
config.system.show
125CLI Reference Guide for Directors and Edge Switches
config.zoning Commands
The config.zoning commands function in a different way from the other CLI
commands, which are single action commands that take effect immediately. A
zoning configuration is typically too complicated to be described by a single
command, so the first zoning command entered invokes a work-area editor. The
commands take effect on a temporary copy of a zone set in the work area until the
temporary copy in the work area is activated to the fabric — or is discarded.
Because not all the verification of the zone set can occur on the temporary copy in
the work area, it is possible, however unlikely, that the copy of the zone set
encounters no errors until the zone set is activated to the fabric.
Note: Port numbers cannot be used for zone members if the interoperability mode for
the switch or director is set to Open Fabric 1.0 mode. In this case, you must use node
WWNs as zone members.
Note: An Edge Switch 2/12 cannot participate in a fabric, unless the Fabric Capable
feature is enabled. For more information, see the
Edge Switch 2/12 Installation
Guide.
The config.zoning commands include the following:
■ config.zoning.setDefZoneState, page 127
■ config.zoning.activateZoneSet, page 128
■ config.zoning.deactivateZoneSet, page 129
■ config.zoning.replaceZoneSet, page 130
■ config.zoning.clearZoneSet, page 131
■ config.zoning.addZone, page 132
■ config.zoning.deleteZone, page 133
■ config.zoning.renameZoneSet, page 134
■ config.zoning.addWwnMem, page 135
■ config.zoning.addPortMem, page 136
■ config.zoning.clearZone, page 138
■ config.zoning.deleteWwnMem, page 139