FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
136 CLI Reference Guide for Directors and Edge Switches
Syntax
addPortMem “zoneName” domainId portNumber
Purpose
This command adds the domain ID and port number of a zone member to the
specified zone in the work area.
Note: Port numbers cannot be used for zone members if the interoperability mode for
the switch or director is set to Open Fabric 1.0 mode.
Description
A product can have a maximum of 1024 zone members in its zones.
Parameters
This command has three parameters:
config.zoning.addPortMem
zoneName Specifies the name of the zone.
domainId Specifies the domain ID of the member to be
added to the zone.
Valid values are in the range 1–31.
portNumber Specifies the port number of the member to be
added to the zone.
Valid port number values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0–23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140