FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
150 CLI Reference Guide for Directors and Edge Switches
Syntax
resetConfig
Purpose
This command resets all NVRAM configuration parameters to their default
values, including feature keys and IP addresses.
Description
This command IPLs the switch. Connection from the CLI to the switch is lost
when this command runs.
Note: This command resets all configuration data and non-volatile settings, including
network information, to their default values (factory settings). Management access may
be lost until the network information is restored.
The default values are set in the firmware of the director or edge switch. For
information about the default values, refer to the service manual for your director
or edge switch.
Parameters
This command has no parameters.
Command Example
Root> maint system resetConfig
maint.system.resetConfig