FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

CLI Commands
172 CLI Reference Guide for Directors and Edge Switches
Syntax
setPath destDomainID sourcePort exitPort
Purpose
This command sets a preferred exit port given the destination domain ID and
source port. An exit port can be set for each combination of destination domain ID
and source port.
Parameters
This command has the following parameters:
perf.preferredPath.setPath
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0-23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140
exitPort Specifies the number of the desired exit port.
Valid port numbers values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0-23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140