FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.preferredPath.showPath
175CLI Reference Guide for Directors and Edge Switches
Syntax
showPath destDomainID sourcePort
Purpose
This command displays the requested Preferred Path configuration. The output
shows the configured preferred exit port. Using all for either the destination
domain ID or the specified sourcePort parameter results in output that shows all
configured and actual exit ports for the other parameter. If the destination domain
is set to all, then all paths from the specified source port are displayed. If the
source port is set to all, the output shows all source port paths to the specified
domain. You cannot specify all for both of those parameters.
Parameters
This command has the following parameters:
perf.preferredPath.showPath
destDomainId Specifies the destination domain ID. Valid
domain IDs are in the range 1–31 or all,
which shows all paths to and from the source
port specified in the sourcePort parameter.
sourcePort Specifies the number of the source port. Valid
port numbers values are:
0–11 for the Edge Switch 2/12
0–15 for the Edge Switch 2/16
0-23 for the Edge Switch 2/24
0–31 for the Edge Switch 2/32
0–63 for the Director 2/64
0–127 and 132–143 for the Director 2/140
Or, you can specify all to show all paths to the
destination domain ID specified for the
destDomainId parameter.